Visceral adipose tissue-derived serpin (Vaspin), a member of serine protease inhibitor family, is a visceral adipose tissue-derived adipokine with potential antiprotease properties.
Vaspin cDNA was isolated by from visceral white adipose tissues (WATs) of Otsuka Long-Evans Tokushima fatty (OLETF) rat, an animal model of abdominal obesity with type 2 diabetes. Human, mouse and rat Vaspin is made up of 395, 394, and 392 amino acids respectively. Vaspin belongs to serine protease inhibitor family and it also shows about 40% homology with 1-antitrypsin.
Vaspin ameliorates certain aberrations seen in the diabetic obesity metabolic syndrome by sensitizing insulin action, especially in WATs.
Research on Vaspin has been trying for the identification of the potential protease substrate leading to the development of antiprotease inhibitor therapy, which could facilitate the improvement of insulin sensitivity in this metabolic syndrome.
- Strip plates and additional reagents allow for use in multiple experiments
- Quantitative protein detection
- Establishes normal range
- The best products for confirmation of antibody array data
The capture antibody provided in this kit recognizes human, mouse and rat Vaspin.
Target Protein Information
Serpin A12 (OL-64) (Visceral adipose tissue-derived serine protease inhibitor) (Vaspin) (Visceral adipose-specific serpin)
- Pre-Coated 96-well Strip Microplate
- Wash Buffer
- Standard Peptide
- Assay Diluent(s)
- Biotinylated Peptide
- TMB One-Step Substrate
- Stop Solution
- Assay Diagram
- Positive Control Sample
- Capture Antibody
- User Manual
Other Materials Required
- Distilled or deionized water
- Precision pipettes to deliver 2 µl to 1 ml volumes
- Adjustable 1-25 ml pipettes for reagent preparation
- 100 ml and 1 liter graduated cylinders
- Tubes to prepare standard and sample dilutions
- Orbital shaker
- Aluminum foil
- Saran Wrap
- Absorbent paper
- Microplate reader capable of measuring absorbance at 450nm
- SigmaPlot software (or other software that can perform four-parameter logistic regression models)
Protocol OutlinePrepare all reagents, samples and standards as instructed.Add 100 µl detection antibody to each well.Incubate 1.5 h at RT or O/N at 4°C.Add 100 µl standard or sample to each well.Incubate 2.5 h at RT.Add 100 µl prepared streptavidin solution.Incubate 45 min at RT.Add 100 µl TMB One-Step Substrate Reagent to each well.Incubate 30 min at RT.Add 50 µl Stop Solution to each well.Read plate at 450 nm immediately.
Standard, Biotinylated Vaspin peptide, and Positive Control should be stored at -20°C after arrival. Avoid multiple freeze-thaws. The remaining kit components may be stored at 4°C. Opened Microplate Wells and antibody (Item N) may be stored for up to 1 month at 2° to 8°C. Return unused wells to the pouch containing desiccant pack and reseal along entire edge.